There are two ways to create a new project:
(1) Network View
(2) Project View 

Network View
Your device must be detected for this method.
Locate the device block. To confirm the device, right click the block > Flash Front Panel.
Double click the device block > Device Option Configuration tab. This will display the current card configuration of the Solaro hardware device.

To select multiple devices, Ctrl+Click the devices. With the device(s) highlighted, at the top right, select Create New Project from Selected Device(s).

A new window will appear. This is Project View. The selected device(s) will populate the grid area. These items match the connected hardware devices. The device Mac address is listed at the bottom of each module.

Project View
To create a blank project, open the Xilica Designer software and select "New Project".
The software will ask you which DSP series you are using. Select Solaro series. 

When a new Project is created, the software will open Project View.

Click and drag a Solaro processor from the Component Library menu (on the left) onto the work area grid.

A Device Option Configuration window will pop-up.

In the Device IO Card Configuration section, configure the Solaro cards. The cards in the hardware must match the design file in order to go online.
Hardware cards slots are numbered right to left. (Right being card slot #1)

XC-SDA: software selectable as input or output card. When configuring IO cards in Xilica Designer, the AES card can be selected as a 2ch input card or 2ch output card.

XC-SUB: To set up the USB audio card, the first card slot must be a 2ch USB audio input followed by 2ch USB audio output.

XC-SGP: GPIO cards can be selected as a 4ch GPIO Input, 4ch GPIO Voltage input or 4ch GPIO output card.



Changing card configuration
If cards are re-configured in the hardware, the software must match new changes. (vice-versa)

Double click the Solaro device in your work area.

In the Object Property menu, easily reconfigure Device IO Card configuration. The cards in the hardware must match the design file in order to go online.
Hardware cards slots are numbered right to left. (Right being card slot #1) 

Configured cards will display in the work area.

XC-SML: 2ch Analogue Audio Input card: Selectable mic/line.
Double click the card module.
48V Phantom power is available per channel. (Premium quality mic pre-amps)
Select Line (0dB), or Mic (+42dB gain in 6dB steps)

GPIO Output Card: Output type is LED or sink (software selectable per channel)Double click the card module to select the type per channel.

Click here to learn how to configure Solaro IO cards in the hardware device.

Did this answer your question?