*You can upgrade multiple plug-in cards at once, however they must be the same card type. Simply insert the card(s) into the Solaro frame and follow the instructions below.

To upgrade your AES/EBU, USB and GPIO plug-in cards,
download the latest plug-in card firmware file (.xfw) from the Xilica website

Holding the IP reset button, power ON the device. 

(Solaro QR1 can be powered either through external power or PoE. In recovery mode, the blue power LED will begin flashing in a special pattern. The device will quickly flash 8 times in one second and then off for another second.)

Connect the device via USB to the host computer.

Launch the Xilica Designer software. Start Network view and select your device.

Under the top tab ‘Device Management’, select ‘Solaro USB Firmware Recovery’ > ‘Solaro Advance Recovery’ > ‘I/O board Firmware Recovery’. Please note that Xilica Designer projects must be closed for this function.

Follow the on-screen instructions to perform the firmware recovery.

This process will take approximately five minutes. Once completed, the device will automatically restart and be ready for use.

Did this answer your question?