Solaro Series are modular architecture devices and therefore allows the user to configure the device I/O using plug-in cards.
Hardware card configuration must match software card configuration in order to go online.
WARNING! Power down the unit before opening the device! Disconnect the device’s power supply, including PoE.
- Power down the unit. Disconnect the power supply, including PoE.
- Remove the side screws and keep them aside.
- Lift the top plate and slide the plate out.
Removing modular cards
Note: Handle with caution. Never pull straight-up or push straight down.
- Using a rocking motion, gently lift each side of the modular card until the card is removed.
- Keep loose modular cards protected in a safe and dry place.
Inserting modular cards
Note: Handle with caution. Never pull straight-up or push straight down.
- Line up the modular card connectors with the pinholes in the empty card slot.
- Using a rocking motion, push gently on each side of the modular card until the card is secured in place.
- Installation is completed when the modular card cannot move down any further.
- Verify the installation afterwards. The unit will not start if the cards are not properly set.
Closing the device
- Line up the top plate with the device and slide the plate back in place.
- Secure the original screws back into place. The screws should fit easily. Do not apply excessive force to secure screws.